Knape & Vogt PSW9-1-20 Guia De Inicio Rapido

Parts Included
A. Waste Bin
B. Wire Cage
C. Sliding Base Assembly
D. Mounting Screw Package
B
A
C
Mounting
Straps
Tools Required
I. Phillips screwdriver
Optional
I. Drill with 1/16˝ bit for pilot holes
II. Pencil
Product Assemblies
Single Bin Units Double Bin Units
PSW9-1-20 PSW15-2-20
PSW12-1-30 PSW15-2-35
PSW12-1-35 PSW18-2-30
PSW15-1-20 PRC12-2-27
PSW18-1-30 R110
R101
KNAPE & VOGT MANUFACTURING COMPANY
P.O. Box 191, Muncie, IN 47308
0.899.6535 • 765.288.8730 • Fax 765.288.0851 • www.kv.com
SLIDING SINGLE & DOUBLE
WASTE BINS
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
Step 1 Place sliding base assembly on cabinet
D
Step 2 - Single Bin
Step 2 - Double bin
WSI MSSU 928-182
floor, in desired position. Position front
Mounting Strap against the back edge
of the cabinet face frame. If installing in
a frameless cabinet, measure 1/2˝ to
3/4˝ back from front of cabinet opening,
and align sliding base assembly parallel
to cabinet opening. Close door to make
sure the assembly will not hold cabinet
door open. Also, check to see if unit will
clear the door opening when fully
extended. Once position is determined,
fasten in place using four mounting
screws provided and a Phillips head
screwdriver.
Optional Step:
Mark placement of mounting holes with
a pencil, remove sliding base assembly
and drill pilot holes for fastening screws.
Place sliding base assembly back into
position and fasten with the provided
screws.
If sliding members are fully extended,
return to closed position. Hold the wire
cage over the sliding base assembly so
that the cage aligns with the clip
retainer built into the side of the sliding
members. The waste bin will sit
perpendicular to the cabinet opening.
Pushing firmly, lower wire cage into clip
retainers until fully seated. Insert bin
into cage to complete the installation.
If sliding members are fully extended,
close unit so that the rear cage clip
retainer–built into the side of the sliding
members–are inside the cabinet.
Beginning with the rear-most wire cage,
hold the cage over the sliding base
assembly so that the cage aligns with
the clip retainer. The bins will sit parallel
to cabinet opening. Pushing firmly, lower
wire cage into clip retainers until fully
seated. Close unit completely and install
front-most wire cage in the same
manner. Insert bins into cages to
complete the installation.
step 1
step 2
step 3
Top View
Single Bin Double Bin
2
1
1
Overall Cabinet Width: Overall Cabinet Width:
12" 18"
RN-R101/110EFS 02/03