Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLE THE CHAIR
Raise the chair to the upright position
1. Plug the power cord into the rear of the chair and then into a a grounded wall outlet.
2. Turn the power switch on the back of the chair to On. The chair inclines to the upright position.
3. Power off the chair, then unplug it.
Install the tablet
1. Match the pins on the tablet cable with the corresponding holes in the socket on the left-hand chair frame,
then insert the connector into the socket (Fig.2).
2. Turn the connector lock clockwise until it is tight to secure the cable (Fig.3).
Fig.2
Fig.3
humantouch.com
Remote cable connector
Remote cable connector
6
Install the side panels
1. Remove the Phillips-head screw and washer from the
front of the left-hand chair frame. NOTE: Use a
manual screw driver and make sure to hold it straight
to avoid stripping the screws (Fig.4).
Screw
Washer
2. Align the four side panel mounting points with the corresponding points on the chair, then slide the side panel into
position. IMPORTANT: The horseshoe bracket is thin and can be difficult to engage; placing pressure on the rear
portion of the side panel while sliding it backward makes it easier (Fig.5).
2
Post
1
Slot
3
Upper bracket
1
Black tab
Lower
bracket
Lower white plastic
mounting point
Fig.4
CONNECTING
1
Black tab to Slot
2
Horseshoe bracket to Post
3
Upper white plastic mounting point to Upper Bracket
2
Horseshoe bracket
3
Upper white plastic
mounting point
Fig.5
7
Tabla de contenido
