Hardware Installation - Steren CCTV-200 Manual De Instrucciones

EXTENDED CONNECTOR
1.- GND
2.- TX RS-232TX
3.- +5V (100mA) Power output
4.- GND
5.- ALM1 Alarm Input
6.- RLY RLY control
7.- RX RS-232 RX
8.- ALM1_G Alarm input GND
+5V Power output: it can supply power for relay or PIR,
maximum current is 100mA
Outer alarm input is a Closed Single RS232 only use for testing

HARDWARE INSTALLATION

1.- Plug the Ethernet cable into RJ-45 jack in the camera.
2.- Plug the extreme end of Ethernet cable into an available LAN
port.
3.- Plug the AC power adaptor in the corresponding input jack.
Then plug into an AC household outlet.
HOW TO INSTALL AND USE THE IP SOFTWARE
1.- Place the installation CD into the CD-ROM drive.
2.- Click over theIPCamSetup.exe icon, twice.
3.- In the followed windows, click Next to continue.
4.- Once the system installed the required fi les, you must restart
the PC.
5.- When the computer rebooted, a new icon will display in the
Windows desktop (IP camera tool). Click twice over the icon, a
new window pop-up where you can see the camera IP address
(in case of you have more than one connected camera, you will
see all the IP address).
ENGLISH-4