Idiomas disponibles
Idiomas disponibles
RFT-1081
RFT-1101
WARNING: PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. FAILURE TO FOLLOW THESE INSTRUCTIONS OR TO INSTALL
THE ENCLOSURE PROPERLY COULD RESULT IN DETACHMENT OF THE ENCLOSURE AND SERIOUS INJURY.
Secure brackets to
floor board
(TOP VIEW)
Straps
2. INSTALL THE MOUNTING STRAPS
Feed each strap through the pair of mounting brackets and position the enclosure in place over the straps. Tighten each strap securely.
NOTE: Be sure the mounting straps are looped through the buckle correctly. Check the straps regularly to ensure your enclosure is securely mounted in place.
Bridged Amplifier
(4Ω)
3. RUN THE SPEAKER CABLE FROM THE AMP
When routing the speaker cable from the amplifier, avoid running it close to any sources of high current (e.g.,wiring harnesses). The positive (+)
speaker output from the amp connects to the red terminal of the enclosure, and the negative (–) connects to the black terminal.
®
8" Box That Rocks
10" Box That Rocks
1. INSTALL THE MOUNTING BRACKETS
Place the enclosure in the desired mounting location and position the mounting
brackets approximately 4" from each end. Push the mounting brackets as close as
possible to the enclosure without moving or lifting it. Carefully remove the enclosure
and secure the brackets using the supplied screws.
NOTE: Be careful not to mount the enclosure on cardboard or plastic panels.
Doing so may allow the screws to pull out from the panel due to road vibration or
sudden vehicle stops.
CAUTION: Before drilling, check under vehicle to avoid damage to brake
or fuel lines, etc.
2"-3" (5-8cm)
+ –
®
– 2 –
Black
Red
Specifications subject to change without notice
Installation
Reference
Sheet
