• Before using your appliance for the first time,
remove the accessories from the packaging and
clean them with hot water.
Use:
• By hand:
• Check that the speed selector (b) is set at "0".
(Fig 1)
• Insert the rods of the whisks (d) or mixers (e) into
their holes. Once in place, both the whisks should
have the same length. The "click" indicates that
the accessories are correctly in place.
• Pull the "power cord storage" compartment (f)
until you hear a "click"; unwind the required cord
length, push back the compartment and then
plug the appliance in
• A deep bowl should be used for mixing.
• To avoid splashing, place the whisks in the
preparation before switching the appliance on.
• Press the speed selector (b) to turn the appliance
on, first on speed 1 then on speed 2 and 3 as the
preparation thickens. Use the "Turbo" position if
the recipe requires higher power.
• Switch the appliance off before removing the
whisks from the preparation (to avoid splashing).
• To remove the whisks (d) or mixers (e), set the
speed selector at 0, unplug the appliance and
then pull the eject ring (c) upwards.
• To store the power cord: pull the compartment
behind the hand mixer until you hear a "click",
wind the power cord and push the compartment
(Fig. 4)
back. (f).
• Use on the stand (g) (depending on model):
• Check that the speed selector (b) is set at "0"
(Fig 1)
• Insert the rods of the whisks (d) or mixers (e) into
their holes. The whisk or mixer with a rotating
(Fig. 1)
(Fig. 2)
.
(Fig. 3)
First Use:
12
EN