How To Start - Troy-Bilt 020210 Manual Del Propietário

Operation
HOW TO USE PRESSURE
WASHER
If you haveany problems operating your pressure washer,
pleasecall the pressure washer helpllne at 1-888-611-6788.
How to Start Engine
The best way to start your pressure washer for the first
time is to follow these instructions step-by-step.This
starting informationalso applies if you have let the unit sit
idle for at least a day.
I. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
5.0 gallons per minute and no tess than 20 PSIat
pressure washer end of garden hose.
2. Make sure unit is in a level position.
3. Check that high pressure hose is connected to spray
gun and pump. See"Preparing PressureWasher for
Use" for illustrations.
4. Connect garden hose to water inlet on pressure
washer pump.Turn ON water.
CAUTION
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
5. Squeeze trigger on gun until you have a steady stream
of water.This purges pump of air and impurities.
6. Attach nozzle extension to spray gun (Figure 7).
Tighten by hand.
7. Choose spray tip you want to use and insert it into
nozzle extension. See"How to Use SprayTips".
8. Apply safety latch to spray gun trigger (Figure 8).
Safety Latch
9. Start engine according to instructionsgiven in engine
owner's manual.
NOTE: If the recoil starter is hard to pull, squeeze the
spray guntrigger to relieve internal pump pressure.
• Squeeze trigger on spray gun each time recoil starter is
pulled and engine fails to start.
How to Stop Pressure Washer
• Turn engine off according to instructions given m engine
owner's manual.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.