Tabla de contenido
Idiomas disponibles
Idiomas disponibles
How to Start Your Pressure Washer
To start your pressure washer for the first time, follow these
instructions step-by-step. This starting information also
applies if you have let the pressure washer sit idle for at least
a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.3 gallons per minute (12.5 liters per minute) and no
less than 20 PSI (1.38 BARS)at pressure washer end
of garden hose. DO NOTsiphon supply water.
2. Checkthat high pressure hose is tightly connected to
spray gun and pump. See Assembly section.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure washer
pump.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment r esulting from failureto follow this
instructionwill voidwarranty.
5. Turn ON water, point spray gun in a safe direction,
press red button and squeeze trigger to purge pump
system of air and impurities.
6. Attach nozzle extension to spray gun. Tighten by hand.
X
,
\
Choose spray tip you want to use and insert it into
nozzle extension. See How to Use Spray Tips.
IMPORTANT:Beforestarting the pressure washer, be sure
'ou are wearing safety goggles as described below.
A. WARNING Risk of eye injury.
Spray can splash back or propel objects.
,
When starting engine, position yourself as
recommended and start engine according to
instructions given in engine operator's manual. Also
see operating instructions tag located on the pressure
washer.
A. WARNING Starter cord kickback (rapid retraction) can
result in bodily injury. Kickback will pull hand and
_,_
arm toward engine faster than you can let go.
v-
Broken bones, fractures, bruises, or sprains
could result.
• NEVERpull starter cord without first relieving spray gun
pressure.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to releasehigh pressure.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVERsubstitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
12
www.troybilt.com
Capítulos
Tabla de contenido
