THERMEx WASTEMINATOR II Instrucciones De Montaje página 67

M 780672000203022015
INSTALLING THE WASTEMINATOR II ON THE SINK
When the drain pipe is mounted on the Wasteminator II, the Wasteminator II is installed in the
sink as follows:
1
Rubber seal
Insert the flange through the hole in the
sink.
NOTE: Remember to install the rubber
seal.
3
Tighten the three screws on the nut so
that the nut does not loosen due to vibra-
tions during use of the Wasteminator II.
Flange
THERMEX WASTEMINATOR 67
2
Fibre disc
Place the rubber seal and fibre disc on the
flange at the underside of the sink and
tighten the nut on the flange.
4
Push the rubber stopper down on the
edge of the Wasteminator II.
Rubber seal
Nut