Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Anleitung_TH_XS_28_SPK8__ 24.09.12 15:21 Seite 16
GB
Use of sanding/grinding paper without the
appropriate dimensions and perforations (Fig. 7/8):
Cut the sanding/grinding paper to fit the
n
corresponding dimensions.
Fit the sanding/grinding paper to the
n
sanding/grinding plate as described above.
Place the rectangular sanding/grinding plate (6)
n
together with the fitted sanding/grinding paper (a)
onto the punch (9) for the sanding/grinding
paper). (Fig. 8)
Now punch the required holes into the
n
sanding/grinding paper.
Remove the punch (9) from the sanding/grinding
n
plate (6).
Check the correct position of the punch holes in
n
the sanding/grinding paper.plate.
5.5.2 Fasting the sanding/grinding paper with
Velcro fastening system
The Velcro fastener enables easy changing of
sanding/grinding paper. Make sure that the
extraction holes on the sanding/grinding paper and
the sanding/grinding disk are aligned.
5.6 Triangular sanding/grinding plate (Fig. 6)
Fit the triangular sanding/grinding plate (8) to use the
equipment as delta sander/grinder.
Fastening the sanding/grinding paper:
The Velcro fastener enables easy changing of
sanding/grinding paper. Make sure that the vacuum
extraction holes on the sanding/grinding paper and
the sanding/grinding disk are aligned.
5.7 Eccentric sanding/grinding plate (Fig. 6)
Fit the eccentric sanding/grinding plate (7) to use the
equipment as eccentric sander/grinder.
Fastening the sanding/grinding paper:
The Velcro fastener enables easy changing of
sanding/grinding paper. Make sure that the vacuum
extraction holes on the sanding/grinding paper and
the sanding/grinding disk are aligned.
16
6. Operation
6.1 Switching the equipment ON/OFF
(Fig. 9/Item 2)
To switch on: Slide the ON/OFF switch (2) forwards
(position I)
To switch off: Slide the ON/OFF switch (2)
backwards (position 0)
6.2 Speed control (Fig. 7/Item 3)
To pre-select the speed turn the knurled screw (3) on
the switch.
Plus direction:
Minus direction:
6.3 Working with the equipment:
Important. Never hold the workpiece you wish to
sand/grind in your hand. Secure the workpiece on a
sturdy surface or with a vise.
Place the whole surface area of the sanding disk
n
on the material.
Switch on the machine and move it with gentle
n
pressure over the workpiece completely circular
movements or moving it to and fro and up and
down.
Use a coarse paper for coarse sanding and a
n
finer paper for finish sanding. You can find the
best paper for the job by means of testing.
Important.
The dust generated when working with the machine
may be harmful.
Always wear goggles and a dust mask when
n
carrying out sanding/grinding work.
Everybody who uses the machine or enters the
n
workplace must wear a dust mask.
Do not eat, drink or smoke at the workplace.
n
Do not use the machine on paints which contain
n
lead.
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
Higher speed
Lower speed
Tabla de contenido
