Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
CAUTION: Many repairs may only be done by a certified service technician.You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that came with the product.
Pre-Installation Requirements
The following tools and equipment are required for installation of an W-6000M3 module:
Pre-installed Dell PowerConnect W-6000 Controller Chassis(sold separately)
ESD-preventive wrist strap (not provided)
#2 Phillips screwdriver (not provided)
Dell PowerConnect W-6000M3 Controller Module(s)
Physical Installation
To install an W-6000M3 module into an W-6000 chassis:
1. Use standard ESD precautions when installing an W-6000M3.
NOTE: Since the Dell W-6000M3 Controller Module is hot-swappable, the power to the chassis can be ON or OFF.
2. Remove the blank front panel or existing module from the appropriate slot in the W-6000 chassis (if
applicable).
NOTE: Dell recommends the use of a blank front panel over any unused slots in an W-6000. The blank front panel is required for
proper cooling and air flow within the W-6000.
3. Remove the W-6000M3 module from the shipping carton and ESD bag.
4. Slide the W-6000M3 into the W-6000 using the guide rails. The W-6000M3 must be seated within the guide
rails for proper installation (see
Dell PowerConnect W-6000M3 Controller Module | Installation Guide
Figure
7).
7
Tabla de contenido
