Dhom Teck Systems FS-40M Manual De Usuario Y De Mantenimiento página 2

COMPONENTS
ASSEMBLY INSTRUCTION
WARNING ! Before connecting the plug to the power outlet, check that all parts are properly assembled and
make sure that the plug is disconnected from the mains during assembly operations.
• Attach the circular upright to the base by inserting it into the central hole.
• Tighten the screw in the underlying base so fasten the mast
• Insert the drive unit on the upright and secure it with the screws.
• Loosen the locking ring to adjust the height and then retighten it.
• Mount the rear protection grille on the engine unit
• Secure the protection grid with the appropriate data
• Fit the propeller to the motor by matching the notch with the locking pin.
• Fix the helix with the closing cover by turning it counterclockwise
• Open the front bezel hooks and match the back bracket.
• Close both hinges by locking the hooks.
Fig. 1
Q - Plate with holes
R - 2 screws
S - Housing for chromed tube
T -, Chromed tube
U - Chromed tube slot
Fig. 2
V - Vite
W - Locking bridge
X - Stand support
Y - Stand Arm
Fig. 3
H - Floor Pipe
Z - Angled screw with washer
Fig.4
A - Motor unit and support
B - Swing key
C- Engine shaft
D - Crankshaft
E - Tilt lock
F - Hanging
G - Height adjustment lock
H - Floor plan
J - Rear grid
K - Grate handle
L - Ring
M - Pala
N - Screw cap for shovel
O - Front grille
P - Vitina a dadino
T - Chromed tube