Tabla de contenido
5. Insert the support (no 3)
as in Fig. K, paying attention
that the wires run through the
slot indicated.
6. Reassemble the plate
holder to the undertray, by
securing the original screws
again ( Fig. L)
Connect the wiring of the
turn signal lights (indicators)
and check correct operation.
Place cables in the undertray
groove and make sure they
do not protrude. As in Fig. M
7. Reassemble the rear
undertray. Press it upward
against the frame and mount
the four bolts (n° 23) applying
some thread locking agent
on the thread. (Fig. N)
7C. In case of Japanese
spec model,please use
original ETC device bolt
for installation.
KAWASAKI MOTORS EUROPE N.V.
P.O. Box 532, 2130AM Hoofddorp
The Netherlands
K
M
7
N
99994-0902
01/08/2016 (V1)
3
L
Pag 5 of 11
Tabla de contenido
