Tripp-Lite T100-001-TST Manual Del Propietário página 3

Operation
Cutting Cable
A single blade for cutting cable is located on the
back of the tool. To use, insert the desired cable
length into the slot labeled "CUT". To cut the cable,
squeeze the handles together until the cable cleanly
separates.
Stripping Flat Cable
On the same side of the tool as the double blades,
insert the cable between the blades. Squeeze the
handles together to score each side of the cable,
then pull off the jacket.
Stripping Round Cable
Insert the cable into the slot labeled "12MM ROUN
CABLE". Squeeze the handles together and rotate
the tool around the cable to score the jacket. Pull off
the jacket.
Crimping Connectors
Once the jacket has been stripped from the
cable, insert the freestanding cable wires into the
appropriate modular connector plug type. Next,
insert the plug into the tool's corresponding 4-Pin
(located on the back), 6-Pin, or 8-Pin slot. Squeeze
the handles to crimp.
3
01-155-9337F4.indb 3 2/20/2018 9:59:40 A