BAUKER MP170 Manual De Instrucciones página 42

a) Do not "jam" a cut-off wheel or apply excessive pressure. Do not attempt to make an
excessive depth of cut. Overstressing the wheel increases the loading and susceptibility
to twisting or snagging of the wheel in the cut and the possibility of kickback or wheel
breakage.
b) Do not position your hand in line with and behind the rotating wheel. When the wheel,
at the point of operation, is moving away from your hand, the possible kickback may
propel the spinning wheel and the power tool directly at you.
c) When wheel is pinched, snagged or when interrupting a cut for any reason, switch off
the power tool and hold the power tool motionless until the wheel comes to complete
stop. Never attempt to remove the cut-off wheel from the cut while the wheel is in
motion otherwise kickback may occur. Investigate and take corrective action to
eliminate the cause of wheel pinching or snagging.
d) Do not restart the cutting operation in the workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel may bind, walk up or kickback if the power tool
is restarted in the workpiece.
e) Support panels or any oversized workpiece to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under their own weight. Supports must be
placed under the workpiece near the line of cut and near the edge of the workpiece on
both sides of the wheel.
f) Use extra caution when making a "pocket cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water pipes, electrical wiring or objects that can
cause kickback.
Safety warnings specific for sanding operations
Note: If these operations are not recommended, this section can be avoided.
Not for use with sanding drums including large. Large diameter sanding drums can
cause kickback and loss of control
81
Safety warnings specific
for cutting operations
Safety warnings specific for sanding operations
Note: If these operations are not recommended, this section can be avoided.
Not for use with sanding drums including large. Large diameter sanding drums can
cause kickback and loss of control
Safety warnings specific for sanding operations
Note: If these operations are not recommended, this section can be avoided.
Do not let brushes or their wires rotate freely because they could damage fingers or the
workpiece.
Safety warnings specific for sanding
operations wire brushing operations
a) Be aware that wire bristles are thrown by the brush even during ordinary operation.
Do not overstress the wires by applying excessive load to the brush. The wire bristles
can easily penetrate light clothing and/or skin.
b) f a brush cover is used, do not interfere with any element between the collet and the
brush. The brush or wheel will be expanding because of centrifugal force.
Instructions for the use
of Mini Grinder
82