Care And Cleaning - LUND 26410015 Instrucciones De Instalación

Installation Steps
At the driver side rear, align the running board bracket with the holes located in Step 1. Install (2) bolts and washers by inserting
them through the rocker panel flange and screwing them into the U-nuts. Next, install (2) more bolts and washers by inserting
them through the top holes in the bracket and screwing them into the rocker panel. Do not fully tighten at this time.
4
5
Inspection After Installation
• Inspect all bolts and nuts for proper tightness.

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
• Do not use cleaning solvents of any kind.
Congratulations!
You have purchased one of the many quality Lund ® branded products offered by Lund International, Inc. We take the utmost pride in
our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product
is top quality in terms of fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Repeat for the bracket at the driver side front and center bracket.
Check boards for final position and tighten all bracket hardware
to 18-20 lb-ft. Repeat Steps 1-6 for passenger side.
800-241-7219 • Visit us at lundinternational.com
© 2014 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
Lund International
Page 3 of 3