HAMPTON BAY 29504 Guía De Uso Y Mantenimiento

PACKAGE CONTENTS
Flower light head Post connector
(glass)
(A)
Assembly and Installation
1
Attaching and installing the
light
IMPORTANT: Do not install the light within 10 ft.
(3 m) of a pool, spa, or fountain.
IMPORTANT: Protect the wiring by routing it in
close proximity to the light, fitting, or next to a
building structure such as a house or a deck.
IMPORTANT: Do not bury the wiring by more
than 6 inches (152mm) in order to connect to
the main secondary wire.
IMPORTANT: Do not connect two long posts (D)
together as it will result in an unstable height.
Any other combination of a single post or two
connected posts is acceptable.
CAUTION: Do not submerge in water. The
product can be damaged.
□
Each fixture can be configured to three
standard heights using the posts and
connectors that are included. The maximum
suggested height is achieved by connecting
one long post (D) and one short post (C).
□
If using more than one post, connect the
posts together using the post connector (B).
□
Route the wire from the flower light head (A)
through the post(s).
□
Attach the fixture stake (E) to the post(s).
(Note that there is a notch on one side of
the stake to allow the fixture's wire to exit
without pinching.)
□
Grasping the base of the post only (do not
use the glass flower light head (A)), gently
push the stake into the ground.
NOTE: Do not use a hammer. If the ground is
hard, use water to soften or a trowel to loosen
the soil.
Use and Care Guide
Low Voltage LED
patent US D659, 273 S
Short post
(B) (C)
Flower Light
Long post Stake
(D) (E)
A
C
E
1
ITEM
MODEL
Transformer Wire connector
(with photocell)
(G)
(F)
A
D
E
Please contact 1-877-527-0313 for further assistance.
#909-015
#29504
TM
Remote
control
(H)
A
D
B
C
E
HAMPTONBAY.COM