Operation; Mode Of Operation - MeisterCraft MMS 800 E Manual Del Usuario

5454210-Multi-Elek-man_a 02.12.11 09:49 Seite 61
used in combination with a suitable hub
stroke (H) and improves the adjustment
of the machine to suit the relevant
materials. At the same time, this also
protects the saw blade, improves the
rate of rejection of shavings and
considerably reduces the formation of
frictional heat. Switching to pendulum
action is also possible when the
machine is running. For
recommendations with regard to device
settings, see Figure 1.
Changing the saw blade (Figure 3)
Pull the saw blade locking lever (6).
Remove any sawdust from the saw
blade holder. Change the saw blade as
shown in the diagram. Ensure that the
guide pin of the lifting rod slots into the
guide hole of the saw blade. It should
not be possible to pull out the saw blade
when the locking lever (6) is released.
CAUTION! Disconnect the power
cable prior to changing the
blade!
Setting the saw shoe (Figure 4)
Press the saw shoe locking button (9)
and slide the saw shoe (3) lengthwise to
the desired position. Release the locking
button. To adapt or to provide a safe
rest for the various materials, the angle
of the saw shoe can also be modified.
8 – Operation
• Switching on: Press the On/Off
switch (1). The machine starts up with
the lowest revolutions. Press down
harder on the switch to increase the
revolutions.
• Switching off: Release the On/Off
switch (1).
The On/Off switch cannot be locked for
continuous operation.
• LED working light
To enable precise working even under
bad lighting conditions, you can
use the LED working light (10). The
2 LED lamps light up the cutting area
(Figure 2).
9 – Mode of operation
Adapt the saw blade, the stroke rate
and the pendulum action to the
material. Remove foreign objects from
the work piece.
CAUTION! When working, always
hold and guide the device by the
handle (7) and the additional handle (8).
The specifications in Figure 1d serve as
orientation. We recommend carrying out
test cuts on waste materials in order to
determine the required device settings
for the project.
CAUTION! Observe the safety
notes!
Switch the device on, and move it
towards the work piece to be
processed. Place the saw shoe (3) on
the surface of the work piece and saw
the material with even pressure and
feed. If the saw blade becomes trapped,
turn the device off immediately. Use a
suitable tool to open up the cut a little
and remove the device. When you have
finished working, switch off the machine
and only put it down when it has come
to a complete standstill.
CAUTION! After working with a
low stroke rate for a long period
of time, operate at maximum
revolutions in idle mode for about
61