Installation And Setting - MeisterCraft MMS 800 E Manual Del Usuario

5454210-Multi-Elek-man_a 02.12.11 09:49 Seite 60
• Always start the unit before
introducing it to the work piece.
• Do not process materials that contain
asbestos. When processing other
materials that contain fibres, use a
face mask and dust extraction unit.
• If the device is to be used outside, it
must be connected via a residual
current circuit-breaker. Extension
cords and plugs must be certified for
outdoor use.
• Do not attempt to stop the saw blade
by applying pressure to the sides.
• Secure the work piece to prevent it
from slipping by using tensioning
mechanisms.
• Make sure that cables always lead
away from the work place.
• During operation, always guide the
device with both hands and ensure
that you are standing firmly.
• The device should never be allowed
to get wet and should not be
operated in a damp environment.
• Prior to each use, check the device,
the cable and the plug. Any damages
should only be repaired by a
specialist. Only plug the device into
the socket when the machine is
switched off.
• When carrying out work in which dust
is generated, wear a face mask and
safety goggles - do not smoke and
avoid naked flames.
60
• When handling saw blades and rough
materials, wear gloves.
• When changing a saw blade, wear
protective gloves to prevent injuries
caused by the sharp cutting edges of
the blade.
• Wear ear-protectors.
• Wear safety goggles.
• Before carrying out any work on the
machine, pull the plug out of the
socket.
• Do not leave keys in the machine.
• Observe the general safety notes for
handling electrical tools.
• Should the connecting cable be
damaged, it must be replaced by the
manufacturer or their customer
representative in order to prevent
risks.
7 – Installation and setting
Pendulum action (P)
The adjustable pendulum
action (5) Figure 1 (P) of the
saw blade (0 for hard
26 mm
materials, up to 3 for soft materials) is