Installation - cabstone CAB WH EASYFIX S-SLIM L Manual Del Usuario

Manual
• The supplied components are only suitable for installation to a solid stone and concrete
wall. If the structure of your wall is different, corresponding installation material must be
used. In any case, consult a specialist.
• Make sure to observe the correct thread size during installation of the display screen to
the wall bracket.

5 Installation:

Wall Installation:
Step 1
Please use the wall bracket (A) as template to mark the position of
attachment to the wall. Check if water or gas pipes, or power lines
are behind the wall before drilling! Use a 60 mm stone drill to bore
the holes with a depth of 60mm. Insert dowels (E) into the 4 drilled
holes. In doing so, a hammer may be useful. Use screws (D) and
washers (H) to attach the wall bracket (A).
Attaching Screen Holders to the Rear Side of the
Step 2
Display Screen:
Make sure the screen holders (B) are parallel to each other and
centered to the display screen. (Figure 2). M4 (G), M5 (M), M6 (N),
and M8 (K/L) screws are supplied for attachment to the display
screen. Other sizes must be purchased from
a specialty shop. A spacer (I/J), and washers (C) are supplied
for M4 (G), M5 (M), M6 (N), and M8 (K/L) screws. You must use
the supplied spacers for display screens with curved rear side
as illustrated in Figure 3. If you have a display screen with
flat rear side, please proceed as illustrated in Figure 4.
Hooking Up:
Step 3
Hook the screen holder (B) onto the top of the wall bracket as
illustrated in Figure 5. Make sure it is securely fastened. Now
place the safety bar (F) into the recess of the screen holder, and
lock it with a key lock, if necessary, as illustrated in Figure 7. (A
key lock is not supplied).
Figure 6: Front view of mounted wall bracket.
Figure 7: Safety bar with key lock. (Example)
The installation is completed. For disassembly the steps
note:
must be carried out in reverse order.
10