Installation - Glacier bay HD67502-5101 Guía De Uso Y Mantenimiento

Installation

1
Installing the connector
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□ Apply thread sealant tape to the threads of the
supply pipe in a clockwise direction, as shown.
□ Thread the connector (B) onto pipe nipple and
tighten the set screw (C) with the Hex wrench
(Hex: 2.5 mm, E) provided.
B
C
E
2
Installing the faucet assembly
□
Rotate the faucet assembly (A) until correct
alignment is made (spout should be pointing
straight down).
□
Push the faucet body onto the connector (B)
over the two o-ring. The splines inside the
faucet body should line up with the splines on
the connector (B).
□
Secure the faucet assembly (A) by tightening
the bottom set screw (D) with the Hex wrench
(Hex: 2.5 mm, E) provided.
A
4
D
E
B