Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2.
Push the ignition lock (5) to UNLOCK position.
3.
Point the torch (3) in a safe direction and pull ignition trigger toward you. Repeat if necessary. Keep ignition trigger (2) depressed and
adjust the flame size by turning the flame regulating knob (4). (Except MT565, that does not include a flame adjustment knob.). When
ignition trigger (2) is released the flame is automatically extinguished.
TO ENGAGE FLAME LOCK FEATURE
1.
While ignition trigger (2) is depressed, press lock button (1).
2.
To release flame lock (1), push ignition trigger until lock button releases.
3.
After flame is extinguished, push the ignition lock to LOCKED position.
AFTER USE
1.
Push the ignition lock (5) to LOCKED position.
2.
Make sure the flame control valve (4) is closed by turning flame adjustment knob fully clockwise until it stops. Do not force. (Except
MT565.)
3.
Remove cylinder from torch when not in use.
4.
With the torch (3) disconnected from the cylinder, point torch in a safe direction and pull ignition (2) trigger to release gas in the torch
ADDITIONAL WARNINGS
•
Make sure the torch is cool before installing or removing cylinder and accessories. Using the torch with a low flame can cause damage
to the burn tube and ignition system.
•
Check all joints and couplings periodically to insure against loose connections. With valve open, without lighting, test all connections
with soapy water. If bubbles appear, gas is leaking and torch must be repaired or replaced. NEVER USE A FLAME TO CHECK FOR
LEAKS. Make this test in a well ventilated and spark-free area and where there are no open flames.
•
In cold weather the size of the flame will be smaller. To produce a larger flame, pre-warm the cylinder to room temperature prior to use.
1.
Slide the ignition lock to the LOCKED position. Make sure flame control valve is closed by turning flame adjustment knob fully clockwise
until it stops. (Except MT565.) Do not force.
2.
When torch is cool, disconnect cylinder and store torch and cylinder separately and out of reach of children. Observe cautions on
cylinder label.
3.
Do not expose cylinders to temperatures in excess of 120ºF.
4.
Store cylinders in well ventilated areas.
CAUTION: Allow tip to sufficiently cool before attempting to swivel or remove tip assembly. Tip may be extremely hot and touching the tip
may result in bodily harm or property damage if touched.
Your torch tip may be swiveled to help you reach hard to reach spots. Simply loosen the black jam nut (see Figure A) and swivel torch into
any position. Hand tighten the jam nut. Take care NOT TO OVER TIGHTEN. Recheck leaks by following procedures highlighted under
"Assembly" above.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET CES INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS DE ATENÇÃO E INSTRUÇÕES
ASSEMBLY AND SWIVEL FUNCTION OF BURNER
200 Old Wilson Bridge Road
Columbus, OH 43085
STORAGE
421757
02/20
MagTorch.com
Tabla de contenido
