After You Have Finished Using Your Appliance; Cleaning And Care - Parkside KM 600 A1 Instrucciones De Uso

4) Depending on what you want to do, fit the
kneading hook 0, whisk q or beater w onto
the drive shaft 7:
–
Fit the kneading hook 0, whisk q or
beater w (hereafter "attachment") onto the
drive shaft 7 so that the two metal pins on
the drive shaft 7 lock into the recesses on
the attachment 0 q w .
–
Push the attachment 0 q w firmly onto
the drive shaft 7 so that the spring com-
presses and turn the attachment 0 q w
anticlockwise a little way (direction
–
Let go of the attachment 0 q w . It is
now firmly attached to the drive shaft 7 .
5) Add the ingredients into the mixing bowl 6 .
When making heavy dough, do not exceed a
maximum flour quantity of 500 g .
ATTENTION! PROPERTY DAMAGE!
► Never exceed a flour quantity of 500 g for
heavy dough!
Otherwise the appliance will be overloaded .
► If the appliance is labouring: switch off the
appliance, remove half the dough and knead
each half separately .
NOTE
► Please note that during the kneading or stirring
process, the mixture in the mixing bowl 6
increases in volume or is pressed upward
slightly as a result of the movement . You
should therefore never fill the mixing bowl 6
right up to the top!
6) Press the release button 2
swivel arm 1 with the mounted attachment 0
q w downwards into the working position .
NOTE
► If you wish, you can fit the filling accessory 8
onto the lid 9:
–
Press the filling accessory 8 into the
cut-out on the lid 9 .
Now you can add ingredients even during
operation .
KM 600 A1
7) Push the lid 9 onto the mixing bowl 6 .
8) Turn the rotary switch 3 to the required level
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch 3
2) Remove the lid 9 from the mixing bowl 6 .
3) Push the release button 2
) .
4) Remove the attachment 0 q w from the drive
5) Remove the mixing bowl 6 by turning it anti-
6) Clean the appliance (see section "Cleaning

Cleaning and care

and press the
(see the section "Speed settings") .
(Position "OFF") .
swivel arm 1 to the highest position .
shaft 7 by pushing the attachment 0 q w
against the drive shaft 7 and turning clock-
wise (direction
you can remove the attachment 0 q w .
clockwise and then pulling it upwards .
and care") .
DANGER – RISK OF ELECTRIC SHOCK!
► Before cleaning the appliance, disconnect
the power plug from the mains power socket!
There is a risk of electric shock!
Never immerse the appliance in water or
any other liquid!
ATTENTION! PROPERTY DAMAGE!
► Do not use abrasive or aggressive cleaning
materials . These may damage the surfaces .
and move the
) at the same time . Then
17
│
GB│IE
■