Heart Rate; Error Messages - Halley Home Run 4.0 Manual Del Usuario

· DISTANCE: Displays the distance covered during the session between 0.00 and 99.99 km, if no training distance has been
set. If you have set a training distance, when you start the session the countdown will start from the distance set to 0.00.
· CALORIES: Displays the distance covered during the session between 0.00 and 99.99 km, if no calorie consumption target
has been set. If you have set a calorie consumption target, when you start the session the countdown will start from the
target set to 0.
· HEART RATE: The monitor will display your heart rate during the session in values between 40 and 180 beats per minute.
Hold the handpulse on the left and right handlebar at the same time, keep 5-10 seconds.
BUTTONS
·  Up-Down/Enter: To adjust settings and navigate through the computer menus, turn the button. To confirm the settings,
press the button. Use this button to adjust the incline.
· START: Press the key to switch on the computer. If you press START during the session, the treadmill will stop and the display
will go into pause mode. To resume the session, press START.
· STOP: Press the key to stop the motor at any moment.
· MODE: To adjust settings and navigate through the computer menus.
· Pause: Press this button to make motor temporary stop working in the running condition.
· Prog.: Press this button has 24 Pre-programs in stop condition.
· User Prog: Press the key to start the customised programme.
· Safety Key: The equipment does not work without the safety key. If the safety key is removed during the session, the
treadmill will stop.
·  Inlcine: Incline adjust.
·  Speed: Speed adjust.
· SPEED SHORTCUT [3-6-9-12]: Press this button, treadmill can reach the speed which you want at any condition.
· INCLINE SHORTCUT [0-3-6-9]: Press this button, treadmill can reach the incline which you want at any condition.
· INCLINE (Left handlebar): Quickly adjusts the incline.
· SPEED (Right handlebar): Quickly adjusts the speed.

ERROR MESSAGES

Display E01
E01: There is a problem with the connection between
the computer and the controller.
SOLUTION: Check the four-pin connector cable bet-
ween the computer and the controller is not loose or
defective.
Display E02
E02: Shows that the voltage line from the motor is not
being checked by the controller.
SOLUTION: Check that the motor cable is properly
connected to the controller.
Display E03
E03: The speed information is not reaching the com-
puter.
SOLUTION: Check that the hole in the disc of the mo-
tor is properly aligned with the light and the sensor.
Display E05
E05: Indicates that the belt friction is too tight for the
motor to function correctly.
SOLUTION: Check that the belt is properly lubricated.
if the error persists, contact the technical service.
OTHER PROBLEM AND SOLVING METHODS
A. Cannot show the data on the console
To check whether power cord is connected, power switch
is opened, SMD fuse is blew out.
If the error persists, contact the technical service.
B. Cannot show the handpulse or error in display
Check handpulse wire if is tight.
Hands in close with the sensor.
Wet your hands with water.
C. Motor cannot be started
Check all of connect wire if is connected.
Observe the fault information on the console.
D. Be short of character
Please contact the technical service.
Home Run 4.0
21