Product Maintenance - Fellowes POWERSHRED W10C Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Up to 5 minutes maximum
Set to Auto-On (I)
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
5 minutes will trigger
20-minute cool down period.
Safety Lock prevents accidental operation.
To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.

PRODUCT MAINTENANCE

OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
1
2
Set to Reverse (R)
Alternate slowly back and forth
for 2-3 seconds
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
2
Feed paper/card
straight into paper
entry and release
To set, wait for shredding to stop, push black button down and slide towards front of shredder.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Set to Off (O)
* Apply oil
across entry
3
4
Set to Off (O)
and unplug
3
When finished shredding
set to OFF (O)
3
Set to Reverse (R)
2-3 seconds
5
6
Gently pull uncut
Set to Auto-On (I) and
paper from paper
resume shredding
entry. Plug in.
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
service under this warranty, please contact us or your dealer.
Shredder doesn't start:
Make sure head is on basket correctly
Wait 20 minutes for motor to cool down
Remove and empty basket
Make sure safety lock is in unlock
position
3
Tabla de contenido
loading

Tabla de contenido