ASROCK Fatal1ty X79 Champion Serie Manual De Instrucciones página 49

Consumer Infrared Module Header
(4-pin CIR1)
(see p.4 No. 35)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.4 No. 40)
1. High Definition Audio supports Jack Sensing, but the panel wire on the
chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
For Windows
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
System Panel Header
(9-pin PANEL1)
(see p.4 No. 23)
Connect the power switch, reset switch and system status indicator on the
chassis to this header according to the pin assignments below. Note the
positive and negative pins before connecting the cables.
PWRBTN (Power Switch):
Connect to the power switch on the chassis front panel. You may configure
the way to turn off your system using the power switch.
Fatal1ty X79 Champion Series Motherboard
This header can be used to
connect the remote controller
receiver.
This is an interface for front
panel audio cable that allows
convenient connection and
control of audio devices.
®
XP / XP 64-bit OS:
® TM
7 / 7 64-bit / Vista / Vista
This header accommodates
several system front panel
functions.
TM
64-bit OS:
49