Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation Instructions - TR11 LED
INSTALLATION
Identify what type of unit is being installed. This will aid you
through the remaining of the installation instructions. Refer
to each section for each specific type of unit. There are
two styles of units (flat and shallow) as described by their
depth of protrusion from the mounting surface (see figures
below). Begin by removing lens assembly using a Torx T20
screwdriver for screws with center pin. (Screwdriver sold
separately, Cooper Lighting Solutions catalog number
VRSD or 1/4" bit VRSB).
Flat Unit Installation
1.
Remove lens, using a TORX T20 center pin reject
screwdriver.
2.
Select the correct type fasteners to use for the
mounting surface, 1/4" nominal diameter (not supplied).
3.
Center mounting plate on flat smooth ceiling or wall
over junction box. Use mounting plate as a template to
layout fastener locations. (Figure 4.)
4.
Connect fixture wires to the proper supply wires and
place in junction box. Minimum 90 deg supply wire
required. Ground fixture with wire provided.
ø11.50
(292.10)
Figure 1. Flat Unit
2
COOPER LIGHTING SOLUTIONS
4.00
(101.60)
IB519021EN
Installation instructions
ø11.44
(290.53)
Figure 2. Shallow Unit
Clearance
Hole for
1/4" Bolt
Gasket
Back - Plate
Lens
Figure 3. Flat Unit Installation
5.60
(142.24)
Tabla de contenido
