Reverse Function - LEITZ IQ Autofeed Small Office 50 P4 Instrucciones De Uso

Leitz Type Models
6
Button / indication & action
Auto-start and stand-by button
(press one time)
Manual reverse button
(hold down)
Manual forward run button
(hold down)
Ready indication
Over heating indication
(Allow to cool)
Overloaded / Jam indication
(Reduce sheet / remove jam)
Bin full indication
This will flash to show when
to clean empty, it will be solid
when the bin must be emptied
Door open or shredder head
removed indication (close door
firmly or replace head on bin)
Hopper locked indication
(unlock by entering 4 digit
combination)
Hopper locking security
combination button 1
Hopper locking security
combination button 2
Hopper locking security
combination button 3
Hopper locking security
combination button 4
Operation
1. Unpack the product.
2. Connect the shredder to mains supply.
3. Ensure the ON/OFF button on the back of the machine is in the
ON position, which will illuminate the blue standby symbol
4. To load the shredder, simply lift the loading door handle to
open the loading door and insert documents. You can open the
door further to 90 degrees for easier access if required. Load
up to MAX sheets at a time into the feed chamber. Do not fill
above the MAX level, this could damage the shredder.
5. The shredder will start the shredding cycle automatically
ONLY after closing the loading door. If there is still paper in the
AutoFeed chamber after first attempt, open and re-close the
paper loading door a second time.
Attention: If required you can now lock the loading door by
entering a 4 digit code (see Locking the Paper Loading Door
section).
6. If you only have a few sheets to shred, you can use the manual
feed slot, provided the auto feed chamber is empty.
7. I nsert paper to be shredded into the feed area. The shredder
will detect the paper and start automatically.
8. I f the shredder is left in auto mode for more than 2 minutes
without being used, the shredder will automatically turn back
to sleep mode in order to save power.
9. The shredder will automatically 'wake up' from sleep mode
when paper is inserted into the shred mouth or you open the
loading door. There is no need to press the Auto button

Reverse function

1. Should you wish to reverse paper out whilst shredding, a
reverse button has been fitted for your convenience.
2. Reverse the paper out then turn the machine off using the ON/
OFF switch at the rear of the shredder. Remove the paper from
the manual feed slot (if being used) or open the loading door,
remove the remaining stack of paper, then pull the jammed
paper free of the cutting mechanism.
3. To resume shredding, turn the shredder on using the ON/OFF
switch at the rear of the shredder, Return the switch to the auto
position .
Locking the paper loading door
For additional security the paper loading door can be locked
during the shredding of confidential material.
To lock shredder:
1. Place documents in tray. Close paper loading door.
2. Press any 4 digits. REMEMBER YOUR CODE!
Shredder unlocks automatically when:
• 4 digit code is re-entered.
• Shredding is complete.
• Shredder is inactive for 30 minutes (but documents remain in
tray)
.
.