Glacier bay 67420-3001 Guía De Uso Y Mantenimiento página 6

Installation (continued)
3
Installing the spout assembly
□
Install the spout assembly (A) onto the
connector (D). Be sure the spout assembly
is resting rmly on the deck.
□
Push down on spout and tighten set screw (B)
with the Hex wrench (AA). Insert the index (C).
C
A
AA
B
D
4
Installing the hot and cold
valves and handle assemblies
□
From underneath the deck, insert the cold end
valve (N) with the rubber washer (O), metal
washer (P), and mounting nut (Q) through the
hole on the right (cold) side.
□
From above, thread the ange (L) onto the valve.
□
Tighten the mounting nut (Q) using a basin
wrench, so that the ange (L) sits ush against
the nished deck surface.
□
Place the handle (K) onto the valve stem (1), and
secure with the screw (J). Use a Phillips
screwdriver to tighten the screw (J). Insert the
index (I).
□
Repeat this procedure for the hot end valve (M)
on the left (hot) side.
M
6
I
J
K
L
1
N
O
P
Q