How To Use Your Oven - Hisense HGO601BS Manual De Funcionamiento Para El Usuario

The various features of this oven are controlled via the knobs and buttons located on the control panels.
Notices: The first time you use your appliance, we recommend that you set the thermostat to the highest
setting and leave the oven on for about half an hour with nothing in it, with the oven door shut. Then,
open the oven door and let the room air. The odour that is often detected during this initial use is due to
the evaporation of substances used to protect the oven during storage and until it is installed.
Notices: Place the dripping pan provided on the bottom shelf of the oven to prevent any sauce and/or
grease from dripping onto the bottom of the oven only when grilling food. For all other types of cooking,
never use the bottom shelf and never place anything on the bottom of the oven when it is in operation
because this could damage the enamel. Always place your cookware (dishes, aluminum foil, etc.) on the
grid provided with the appliances inserted especially along the oven guides.
The oven knob (F)
This knob is used not only to select the different oven modes, but also to choose the right cooking
temperature from among the temperatures shown on the knob itself (from 150 to 250) for the food to be
cooked in the oven. The electronic ignition device of the oven is built into the control knob itself.
bottom gas burning function
To light the oven burner, press the oven knob "F" in all the way and turn it, setting it to the
setting it to the Max position (keeping the oven door shut). Since the oven is equipped with a safety
device, after lighting the burner keep knob "F" pressed in for about 6 seconds to allow the gas to pass
until the safety thermocouple is heated. The electronic ignition device of the oven burner must not be
activated for more than 15 seconds. If the burner fails to light after 15 seconds, stop pressing knob "F",
open the oven door and wait for at least one minute before your try to light the burner again. The
cooking temperature is selected by matching the desired temperature with the reference mark on the
control panel; the complete range of temperatures is shown below:
The oven will automatically reach the temperature set, and the thermostat, which is controlled by the
knob, will keep it constant.
Lighting the oven manually
In the event of a brief power failure, the oven burner can be lit by hand if you choose the bottom gas
burning function:
a) open the oven door
b) hold a match or lighter near the burner hold as shown in the figure, press knob "F", in fully and turn
it anticlockwise, setting it to the Max position. Since the oven is equipped with a safety device, after
lighting the burner keep knob "F" pressed in for about 6 seconds to allow the gas to pass until the
safety thermocouple is heated.
c) Once the burner is lit, shut the oven door.
Importance Notice: should the burner flame accidentally go out, turn control knob "F" to the off
position, open the oven door and wait for at least one minute before trying to light the burner again.

How to use your oven?

- 5 -
,