EN
IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
» Care & Safety Advice
•
Please follow the instructions as listed in this manual.
•
Sort the parts and check against the contents list.
•
For safety purposes we strongly recommend the product to be assembled by
at least two people.
•
Some parts have metal edges. Please be careful when handling components.
•
Always wear gloves, shoes and safety goggles during assembly.
•
Do not attempt to assemble the Gazebo in windy or wet conditions.
•
Dispose of all plastic bags safely – keep them away from children's reach.
•
Keep children away from the assembly area.
•
Do not attempt to assemble the Gazebo if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
•
When using a stepladder or power tools, make sure that you are following the
manufacturer's safety advice.
•
Do not climb or stand on the roof.
•
Heavy articles should not be leaned against the poles.
•
Keep roof and gutters clean of snow, dirt & leaves.
•
Heavy snow load on roof can damage the Gazebo, making it unsafe to stand
below or nearby.
•
This product was designed and produced for it's aimed purpose only.
If color was scratched during assembly it can be fixed with the following tints:
Grey – RAL 7012
» Cleaning Instructions
In order to clean the Gazebo, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean
the panels.
» Tools & Equipment
TOO1(Supplied)
» During Assembly
5mm
10mm
During assembly use a soft surface below the parts to avoid scratches and damages.
3/16"
25/64"
When encountering the information icon, please refer to the
relevant assembly step for additional comments and assistance.
Step 6: Carefully spread silicone along the cross-section of the profile and
immediately attach the profiles together. It is recommended to wipe the extra
residue silicone.
Step 7: It is recommended to use a carton or other soft material under the lowered
corner in order to avoid scratches and peeling of paint.
*This note also refers to steps 9,10,12
Step 10: Optional - if you wish to add curtains / mosquito netting -
Please thread the plastic clips through the rail in each profile.
(Curtains / mosquito netting are not supplied).
Add clips according to the specific quantity of curtain rings.
Steps 12a+14a: Please note that screws insertion should be done from the outside.
Steps 13+15: Please note that screws insertion should be done from the bottom up.
Afterwards please use the tool T001.
Step 16b: Please add silicone on the inner area of part #7661 as illustrated.
Step 21a: Please drill holes in the panels to be located precisely parallel to the holes
in profiles #7663.
Step 22: Please level the profiles' legs and adapt screws and plugs to your specific
ground type.
Please tighten all screws when completing assembly.
SILICONE \
13mm
CAULK
