Rowenta FIRST CLASS DA1510 Manual De Instrucciones página 7

Storing your
iron.
Problems
and possible causes
• The temperature selected is too low.
• The steam control is set on OFF.
• There is no water in the tank
• You have been using the burst of
steam button too often.
• Steam is used before the iron is hot
enough.
• The iron is stored with water in th
tank.
• The problem persists.
HELPLINE:
if you have any product problems or queries, please contact our Customer Relations
Team first for expert help and advice:
Your iron produces little or no steam
.
Water is dripping from the holes in the soleplate
0845 602 1454 - UK
(01) 677 4003 - Ireland
or consult our website - www.rowenta.co.uk
NO
Solutions
Set the temperature control on •••
Switch the steam control to ON.
Fill the water tank.
Wait a few seconds between each
shot.
Set the thermostat within the coloured
steam zone and wait until the iron is
hot (approx. 2 min.).
Empty the tank before storing the iron
and set the steam control to OFF.
Take your iron to an Approved
Service Centre.
6
EN
10 min