EAS ELECTRIC EMRH908TX Manual De Instrucciones página 35

• Before changing the light module(s), unplug
Dismantle LED linght module
the appliance from the mains or switch off
the circuit breaker in the fuse box.
Remove the grease filter and carefully
•
remove the 2 screws from the front plate (a
cross headed screwdriver will be needed to
remove the screws).
• Disconnect the terminal of LED light.
• Press LED light on the back of the front
plate, take the LED light out.
• Replace the lamp(commercially available
LED lamp (max.1.5w).
Reinstall LED light module
Max Power
Square / Diameter
: 33.2mm x 120mm
• Press LED light on the front of front plate,
install the LED light on the front plate.
• Connect the terminal of LED light and light
leads.
Carefully fasten the 2 screws on the front
•
plate ,reinstall the grease filter.
Voltage
1.5W DC 12 V
Picture
35
Lamp Cap ILCOS D code
DSS-1.5-S-33.2
——
/120
V.1