Harness - Foppa Pedretti Logik I-Size Manual De Instrucciones

HARNESS

Loosening the harness: press the adjustment
button A and at the same time grasp the straps
(chest belts) in the lower part, below the chest
protector padding, and pull them forwards to
loosen them.
IMPORTANT: Do not pull on the straps by
gripping the chest protector padding.
Press the red button (18) on the central buckle
(20) to release the shoulder straps and place
them on the sides of the car seat.
Place the child into the car seat. Slide the straps over the child's
shoulders and join the two ends/tabs of the straps together (19), to
form a single connector.
Insert the connector into the central buckle until you hear a click.
Make sure that the straps are not twisted.
Ensure that the straps are positioned just above the child's shoulders and that there is a
space of about 1 cm (for more details see point 1, "Adjusting the headrest").
Tightening the harness: Pull the harness adjustment strap so as to tighten it properly
against the body of the child. The harness is correctly tightened when the gap between
the harness and the child is no greater than the thickness of your finger.
IMPORTANT! Pull the end of the adjustment strap outwards, not upwards or downwards.
FOR THE SAFETY OF YOUR CHILD
To ensure the safety of your child, check before setting off that:
• the ISOFIX connectors (3) are attached to the vehicle and the support leg (1) is
positioned correctly;
• the car seat is locked in the forward-facing or rear-facing position;
• the headrest is adjusted to an appropriate height;
• the 5-point seat belt is adjusted according to the child's body, the shoulder straps
(17) are not twisted and the harness is locked;
• the support leg (1) is in contact with the vehicle floor and its indicator (10) is green.
• For infants and children who are unable to sit up independently (up to 1 year), the car
seat is installed facing backwards and in the most reclined position possible.
• ENGLISH •
USING THE CAR SEAT IN THE VEHICLE
39