Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Pickup Bed Preparation
1.
NOTE:
Read this entire section before drilling to reduce risk of damage to pickup bed.
2.
Locate the four dimples in the bed floor. These indicate the center of the holes to be drilled that will allow the 5
hitch mounting pucks to pass through the pickup bed.
Using a 3" hole saw cut the 4 outer puck holes (See Figure 3).
3.
1.
NOTE: DO NOT Drill the center dimple!
4.
Deburr the rough edges of the 4 drilled holes.
5.
Apply corrosion preventative to raw edges of drilled holes.
©
2019 Horizon Global
30886N
Page 3 of 8
FIGURE 3
6/24/19
th
wheel
Rev. B
Tabla de contenido
