PowerWalker VI CW Serie Guía Rápida página 5

ENGLISH
Site wiring fault
EPO enabled
Over temperature
(Error 41)
Charger failure
(Error 45)
Battery fault
Battery replacement
EEPROM error
VI. Button operation
ON/Mute Button
Press and hold ON/Mute button for at least 2 seconds to turn on the UPS.
•
When the UPS is on battery mode, press and hold this button for at least 3 seconds to
•
disable or enable the alarm system. But it's not applied to the situations when warnings
or errors occur.
• Press this button to display previous selection in UPS setting mode (up key)
Press and hold ON/Mute button for 3 seconds to enter UPS self-testing while in AC
•
mode, ECO mode, or converter mode.
OFF/Enter Button
• Press and hold this button at least 2 seconds to turn off the UPS. UPS will be in standby
mode under power normal or transfer to "Bypass" mode if the "Bypass enabled" setting
is activated.
Press this button to confirm selection in UPS setting mode.
•
Select Button
Press this button to change the LCD message for input voltage, input frequency, battery
•
voltage, output voltage and output frequency.
Press and hold this button for 3 seconds to enter UPS setting mode when UPS is in
•
standby mode or "bypass" mode.
• Press this button to display next selection in UPS setting mode. (down key)
ON/Mute + Select Button
• When the input power is normal, press the two buttons simultaneously for 3 seconds.
Then UPS will enter to the „bypass" mode. This action will be ineffective when the input
voltage is out of acceptable range.
• In setting mode, press the two buttons simultaneously for 0.2s to exit the setting mode.
Sounding every 2 seconds
Sounding every 2 seconds
Sounding every 2 seconds
Sounding every 2 seconds
Sounding every 2 seconds
(UPS remains off to
enforce the battery
check)
Sounding every 2 seconds
Sounding every 2 seconds
No
No
No
No
No
No
No