Campingaz 400 SGR Instrucciones De Empleo página 20

C - PREPARATION FOR USE
C-1 GAS CYLINDER AND REGULATOR
When connecting or changing a cylinder, always operate in
an open, well-ventilated place, and never in the presence
of a lame, spark or any other source of heat.
This unit can be used with a CAMPINGAZ® butane cylinder
type 904 or 907 and the CAMPINGAZ® 28-30 mbar or 50
mbar regulator.
It can also be used with other, larger, butane or propane
cylinders (5~15 kg) and the appropriate relief valves
(consult your dealer):
France, Belgium, Luxembourg, U.K., Ireland, Portugal,
Spain, Italy:
butane 28-30 mbar / propane 37 mbar
Norway, Sweden, Denmark, Finland, Netherlands,
Czech Republic, Hungary, Croatia, Turkey:
butane 30 mbar / propane 30 mbar
Switzerland, Germany, Austria:
butane 50 mbar / propane 50 mbar.
C-2 HOSES (FIG. 11)
Hose length should not exceed 1.50 meter. It must be
replaced if it is damaged or cracked, when required by
national regulations or when the expiry date on the hose
is passed. Do not pull on the hose or twist it. Keep the hose
away from any parts that may become hot. ** When the
hose connection is set up, check for gas leaks following
the instructions in section § D-1.
France:
The device must be used with a lexible hose designed to
be itted into a threaded end piece on the device side and
GB
held in place on the regulator with clamps (Standard XP D
36-110), recommended length 1.25 m.
Appliance
Install the hose as described in the assembly instructions,
supplied with the hose and collars.
Belgium, Luxembourg, United Kingdom, Ireland,
Portugal, Spain, Italy, Croatia, Greece, Netherlands,
Czech Republic, Slovakia, Hungary, Slovenia, Norway,
Sweden, Denmark, Finland, Bulgaria, Turkey, Romania,
Poland:
The appliance is equipped with a circular connector. It
should be used with lexible hose that is suitable for use
with butane and propane gas.
Switzerland, Germany, Austria:
The appliance should be used with lexible tubing that is
suitable for use with butane and propane gas.
To connect the hose to the connector on the appliance,
tighten the nut on the hose irmly but without excess force
using two wrenches:
• no. 10 wrench to tighten the gas inlet on appliance
• no. 17 wrench to tighten the nut on the hose
Connect the other end to the regulator outlet.
D - CONNECTING THE GAS CYLINDER
Use a regulator compliant with EN 12864 or EN16129.
Campingaz's regulator is recommended (see section § C-1).
An adjustment valve must be present on the gas cylinder
or on regulator.
When replacing an empty cylinder, read Section § F:
"Removing or changing the gas cylinder".
When installing or removing a gas cylinder, always
operate in an open, very well-ventilated place, never in
the presence of a lame, spark or any other source of heat
(cigarette, electrical appliance, etc.), and away from other
persons or inlammable materials.
Regulator
1. Place the gas cylinder on the ground, behind or next to
the appliance.
2. Check that the lexible hose is in place normally, with no
torsion or traction. Keep the hose away from any parts
that may become hot.
20
10
17
Whatever the height H
and diameter D or the
maximum width of the
H
gas cylinder, do not put
the gas cylinder under
the appliance.
D