ShenPaz Focus 4010 Manual De Instrucciones página 18

5.3 5.3 Changing Parameters during Cycle
In order to change parameters during cycle, perform the following steps:
Using the HOLD/RELEASE function, during a cycle, enables to change the value of the
parameters that haven't been performed yet. These changes are temporary and do not
effect on the pre-programmed data in the cycle. In order to change the parameters
during cycle the following steps are required:
Press "HOLD" key –Press Menu+ Edit current program.
Scroll through the parameters, by using the arrows keys, until you
reach the parameter (s) that are required to be changed (only the
changeable parameter will appear in an editing Blank field) . Enter the
new value and press ENTER. While you are not able to perform
change on the parameter the word "NO EDIT" will appear on the
active field.
Press HOLD, to release
From the HOLD stage and the furnace will resume the cycle.
The furnace will execute the cycle according the new parameters. After termination of
the cycle the parameters will return to their original values.
5.4 Night-mode
There are two ways to enter Night-mode:-
EITHER During a cycle, press the [ON/OFF] (Front panel) key. On completion of the
firing cycle the furnace will automatically enter Night mode.
The automatic night-mode is indicated by the name Night-Mode in the bottom of the
screen.
The night mode waits until the firing chamber temperature drops to 100C. During this
time the chamber remains open and the table is resting at it lowest position. After the
temperature reaches 100°C the platform will close and maintains the furnace at the
constant temperature of 100C.
To cancel automatic night - mode press ON/OFF key .
OR If the furnace is not in cycle : Enter the pre-programmed cycle [PROG], [0],
[ENTER], arrow up can close door before reaching 100 degrees .
The lift will close the muffle, and the temperature will drop to 100C.To cancel night-mode
press the [STOP/LIFT] key to lower the table and enter the required program number.
FOCUS 4010/HT Dental Porcelain Furnace Page 18 Manual version 20.08.2015