BEMIS bioBidet HD-5000 Manual Del Propietário página 8

WATER CONNECTION (CONT.)
5. Connect the bidet
supply hose.
• Connect the bidet supply hose
to the metal inlet on the side
of the bidet seat. Connect the
other end of the hose to the
T-valve and tighten snugly. Be
careful not to over-tighten.
14
6. Slowly open the water
valve to check if there is
any leakage.
7. Wipe the hoses and connectors thoroughly with a towel and
carefully observe for any leaks for at least 10 minutes.
• Tighten any connectors gently until leakage stops. If any leaks continue,
turn off the water supply and check older hoses for damaged rubber
o-rings. Teflon tape may be used on connections to help seal.
Contact Bio Bidet support if additional assistance is needed.
15