Marina 360 Manual De Instrucciones página 5

2 - INTRODUCING FISH
ADD A HEATER
filter cartridges (ill. D)
DO NOT ADD FISH IMMEDIATELY.
into your aquarium.
ATTENTION: Do not move the Marina 360° once it is full of water.
FEEDING YOUR FISH
DO NOT OVERFEED YOUR FISH
consume in two minutes. once a day.
3 - AQUARIUM CARE AND MAINTENANCE
WARNING: ALWAYS DISCONNECT APPLIANCES IN THE AQUARIUM FROM THE ELECTRICAL SUPPLY BEFORE PLACING HANDS IN THEWATER, BEFORE PUTTING ON OR TAKING OFF
PARTS, AND WHENEVER THE FILTER EQUIPMENT IS BEING INSTALLED, MAINTAINED OR HANDLED.
DO NOT
water, and may cause damage to the unit or the support surface.
DO NOT USE OR PLACE ANYTHING THAT HAS COME IN CONTACT WITH SOAP IN THE AQUARIUM
REGULAR MAINTENANCE
gravel cleaner to ensure cleanliness and to reduce build up of unwanted nitrate and waste. Replace with tap water of similar temperature, and add the correct doses of water
conditioner and biological aquarium supplement. NOTE:
REPLACING FILTER CARTRIDGES
not to change all cartridges at the same time to ensure proper biological filtration.
1.
MOTOR CLEANING
should the filter stop running at any point. Replace impeller yearly for optimal performance.
maintenance. Keeping the impeller clean reduces wear, lengthens its life and the life of
the motor.
1.
2. Remove the inlet cover and then the impeller cover. Pull the impeller from the
impeller well (ill. H).
3. Rinse impeller under water and wash off any slimy build-up that has accumulated
on the impeller and in the impeller well, and reassemble.
Important: DO NOT use chemical cleaners.
4.
CLEANING THE FILTER/LED UNIT
1.
Wipe unit with damp cloth.
2. Rinse filter tube or clean with a Marina cleaning brush.
(ill. E).
NOTE:
(ill. F), rinse thoroughly with tap
(ill. G).
F
G
D
E
2
1
F
H