Control Panel - LG SIGNATURE LUDP890 Serie El Manual Del Propietario

30 OPERATION

Control Panel

Power
a
• Press the Power button to turn power on
and off.
• After the cycle is complete, the power
automatically turns off for purposes of
safety and economy.
• If there is a power surge, power outage,
or disruption of any kind, power is
automatically turned off for safety.
• When power is connected again, it will turn
on automatically and resume the cycle.
Sanitized
b
• If the Steam option is added to a cycle,
the Sanitized indicator stays lit at the end
of the cycle if the dishes were properly
sanitized.
Digital Display
c
The digital display on the control panel
shows the ESTIMATED cycle time. When
the cycle and options are selected, the
display shows the total estimated time to
complete those selections. During operation,
the display shows the remaining estimated
operating time.
NOTE
• The estimated time shown on the display
does not include delay times for heating
water, etc.
• If Delay Start is selected, the display
shows the delay time in hours.
• Cycle time may vary depending on the soil
level of your load.
Rinse Refill
d
This lamp illuminates when the rinse aid level
is low. The LED automatically shuts off when
the rinse aid is refilled or the level is set to 0.
Start
e
• To operate the machine, either press Start
and close the door within four seconds or
close the door and press Start.
• If Start button is not pressed to start the
cycle, an alert will sound.
Cancel
f
The drain pump activates and the cycle
cancels. Once the dishwasher finishes
draining, the power turns off.
• Press and hold Start for three seconds to
activate.
Wi-Fi f
g
When the appliance is connected to the
internet through a home Wi-Fi network, this
icon illuminates.
• Press and hold Delay Start for
approximately three seconds to connect to
the network.
Chime On/Off
h
• To activate or deactivate the button
sounds, press the Half Load button for
three seconds. The error alert sound
cannot be turned off.
Control Lock CL
i
The Control Lock feature helps prevent
settings from being changed during a cycle.
Selecting this feature locks all of the buttons,
except for the Power button, on the control
panel. This feature does not lock the door.
• While a cycle is running, press and hold
Dual Zone for three seconds to activate or
deactivate Control Lock.
• To start a new cycle, deactivate Control
Lock.