Idiomas disponibles
Idiomas disponibles
turn counter-clockwise
E
5
Open the cover of the driver compartment by loosening the two screws
counter-clockwise with a phillips screwdriver; Loosen the 2 NPT1/2
"stoppers and screwing the AC cable with conduit (not included in the
accessories) into the NPT1/2" hole.
SUSPENDER MOUNT
NPT3/4"
G
Take out the rotary union (G) and screw it into the suspender (not
1
included), ensure the joint doesn't drop out by fastening the screw(E) into
the rotary union side.
DIM+(PURPLE)
DIM-(CRAY)
D
L(BLACK)
N(WHITE)
GND(BLUE)
E
6
Connect the Line & Neutral and GND (black, white and green) wires from the fixture to the
same color wires from the AC power by wire connectors (CC) (if there is a dimmer, connect
the purple line vs the purple line and the gray line vs the gray line), and then put the cable
and connectors to the driver compartment, and close the driver compartment as originally.
Note: The black line is L, the white line is N, the green line is GND, the purple line is DIM+
and the gray line is DIM-.
E
A
Thread the wires into the driver compartment through the center hole,
2
and lock the rotary union (G) into the hole and secure it by the short
screw(E).
