Silentaire 558041410 Manual De Uso Y Cuidado

NOTE: Keep your receipt and these instructions for proof of purchase.
WARNING: Shut off the power at the circuit breaker or fuse panel before
removing the old fixture, ballast, or fluorescent tubes.
If you are unfamiliar with electrical installations, we recommend you contact a
qualified electrician to do the installation.
INSTALLATION
Select a suitable location that can support the weight of the fixture. Determine the
method of mounting before drilling.
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires
you are working on is shut off. Either remove the fuse or turn off the circuit
breaker before removing the existing light fixture or installing the new one.
With power disconnected to your electrical box, remove the existing fixture.
Make a sketch of how the current fixture is wired (by wire color) or mark the
wires with masking tape and a pencil so you will know how to properly
reconnect the wires to the new LED light fixture.
NOTE: The fixture's net weight is 9.15lbs (without accessories), The minimum
load-bearing capacity required for the ceiling hook is 38.5lbs (4 times
the high bay weight)
SUSPENDED MOUNT
turn clockwise
C
E
1
Take out the hook (C), screw it into the top of the driver compartment,
and mount the hook (C) with short screw (E) tightly, as shown in the
above figure.
B
3
Take out the mounting chain (B), hang the S-hook of the head into the waist
ring of the tail to form a closing ring, close the opening hook with the S-hook
with pliers, and then hang the mounting chain (B) onto the lifting ring from the
last step (not included in the accessories).
USE AND CARE GUIDE
SILENTAIRE UVC ROUND HIGHBAY
PACKAGE CONTENTS
Part Description
A Fixture
B Mounting Chain
C Lifting Hook
D Wire Connector
E Short Screw
F Long Screw
G Rotary Union
AVAILABLE ACCESSORIES
SOLD SEPARATELY*
MODEL #
010679201
2
4
Part # EP-SAHB-RM-22500LM-8-50K-MV-LVD
Quantity
1
1
1
5
5
1
1
Description Quantity
Prismatic Reflector (OPR) 1
Mounting to a drywall ceiling:
• Drill two holes large enough to clear the
closed flaps of the butterfly nut on a toggle
bolt (not included).
• Fasten the toggle bolt into the butterfly nut
before inserting the flaps into the ceiling.
• Tighten the toggle bolt.
Mounting to a wood ceiling:
• Drill two 1/16 in. diameter holes in the ceiling
to accommodate hook screws (not included).
• Tighten the hook screw (not included) into
the ceiling.
B
turn clockwise
F
C
Hang the fixture on the mounting chain (B), take out the long screw (F) and fix it
on the side of the hook (C), as shown in the above figure.
Model # 558041410
A B
D E F
Optional Prismatic Reflector*
C
G