1
General warnings
1.1
Guarantee and responsibility
The rights to the guarantee and the responsibility will no longer
be valid in the event of damage to things or injury to people, if
such damage/injury was due to any of the following causes:
intervention of unqualified personnel;
carrying out of unauthorised modifications on the equipment;
powering of the burner with unsuitable fuels;
faults in the fuel supply system;
repairs and/or overhauls incorrectly carried out;
use of non-original components, including spare parts, kits,
accessories and optional;
force majeure.
The manufacturer furthermore declines any and every responsi-
bility for the failure to observe the contents of this manual.
1.2
Installation safety notes
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
Isolate the fuel supply.
DANGER
2
Installation
2.1
Fuel remote selection kit installation
The kit consists of two timers to be fitted as shown below.
After fitting, check the timer settings:
–
- DIP switch (1 - 2 - 3 - 4 - 5) as shown in Fig. 20;
–
- timer index on 3 (Fig. 20).
With these settings the timers are set to:
–
- time scale: 0.5 - 10 s.
–
- function: ON delay.
Connect a free contact selector on the main terminal box (see
Fig. 19) as shown in the electrical diagram (Fig. 22).
NOTE:
The external fuel selector operate only if the selector on the
burner panel board is on "0" position, as shown in Fig. 21.
Any selection via the electrical panel selector cuts out the
external selector.
FUEL REMOTE SELECTION KIT
–
–
–
–
5
GB
Personnel must always use the personal protective equip-
ment envisaged by legislation and follow the indications giv-
en in this manual.
Personnel must observe all the danger and caution indica-
tions shown on the machine.
Personnel must not carry out, on their own initiative, opera-
tions or interventions that are not within their province.
Personnel must inform their superiors of every problem or
dangerous situation that may arise.
The installation must be carried out by qualified
personnel, as indicated in this manual and in com-
pliance with the standards and legal requisites in
force.
WARNING
After removing all the packaging, check the integ-
rity of the contents. If in doubt, do not use the
spare part; contact the supplier.
CAUTION
2916101