Kobalt KXRS 124B-03 Manual Del Usuario página 10

OPERATING INSTRUCTIONS
WARNING
• The saw blade may be very hot after use. Allow the blade to cool down or wear gloves when
removing a saw blade.
• Use only a standard reciprocating saw blade. Never try to use T- or U-shaped jig saw blade.
Failure to heed this warning could cause loss of control and can result in possible serious
injury.
3. Variable-Speed Trigger and Switch-Lock
Button
Your reciprocating saw is equipped with a variable-
speed trigger switch (G) to turn the saw on and off
and to control the speed. The switch-lock button
(F) can lock the switch in in the off position.
a. To turn the saw ON, press the trigger-lock
button marked
then squeeze the variable-speed trigger
switch.
b. To turn it OFF, release the trigger switch.
Press the trigger-lock button marked
the switch OFF aand reduce the chance of
unintentionally starting the tool/
c. To vary the speed, simply increase or
decrease the pressure on the variable-speed trigger switch. The more tightly the variable
speed trigger switch is squeezed, the higher the speed will be.
4. LED Work light
The LED work light (C), located on the front of
the saw, will illuminate when the trigger switch is
depressed. This provides additional light on the
surface of the workpiece for operation in lower-
light conditions.
The LED work light will turn off approximately 10
seconds after the trigger switch is released.
a. The LED work light will blink rapidly if the tool
has stopped working because of an overload
or overheating situation; please wait for the
tool to cool down, at which point it can be
started again.
b. The LED work light will blink slowly to indicate
that the battery charge is very low.
to unlock the switch, and
3
to lock
4
C
10
G
F