Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
01.
Check that the main switch is off.
02.
Connect the plugs to the main
(220/240V - 50/60Hz - 6.8A).
Remove the tank top cover.
03.
Extract and direct the two tank tubes towards the back of
04.
the machine
05.
Remove the tank and fill with water.
06.
Reinsert the tank. Make sure that the end of the filter is
submerged at the bottom of the tank
07.
Press the main switch. The machine will start to load water
into the boiler while the blue light flashes slowly.
08.
If the load of water into the tank lasts more tan 2 minutes,
the blue light will start to flash quickly and charge will stop.
Check that there is still enought water in the tank, switch off
and on again, and load will start again.
09.
When the required level of water in the boiler has been
reached, the blue light will remain on and the machine
will start to heat up, then the red light will light up.
10.
Wait for 8 minutes for the temperature inside the boiler
reach its working level. Meanwhile, the air can be bled
from the hydraulic circuit by pressing the dispensing
switch until water comes out of the group.
Make sure that both the steamer and water taps are
closed.
11.
When the red light switched off for the first time, the
boiler temperatura has been reached. Now you can
start using coffee, hot wáter and steam services.
01
START UP
Tabla de contenido
