Turning the drive system back on after a standstill
→ Your e-bike will come to a standstill as soon as it is switched off.
The drive system (not the battery!) automatically switches off:
• after being stationary for 15 minutes.
► Press the centre button C2 to turn the drive system back on.
The battery automatically switches off:
• after 8 hours of standstill (provided no button/touch sensor is
pressed during this time).
or
• after 3 hours of standstill (provided that the charge level of the
battery falls below 30 % and no button/touch sensor is pressed
during this time).
► On the Battery 250, press the on/off button D4 to turn the battery back
on.
or
► On the Battery 250 X, press the centre button C2 on the remote or the
on/off button D4 to turn the battery back on.
Switching the "Pushing support" mode on and off
→ The "Pushing support" mode is available for model-dependent equipment
with Remote b.
1. Change to the support level "none".
2. Hold down the lower button C3 . After 2 seconds the pushing support
is activated and sets the e-bike in motion as long as you keep the button
pressed (max. 6 km/h).
3. Ride the e-bike with both hands. Slow down the e-bike to your walking
speed by holding or restraining the e-bike.
4. Release the bottom button C3 to turn pushing support back off.
| evation
13