Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Install Hitch – Tape (2) 1/2'' and (2) 3/8'' flat washers ①② on the hitch brackets and align holes with hitch bracket slots. Insert Carr. Bolt and spacer into tow
hook ③⑨, see figure 1. Raise hitch into position, over the exhaust, and loosely install 1/2'' carriage bolt, spacer, nut, and conical washer ③⑦⑤⑧ at the
lower innermost holes of end panel, both sides, see figure 1. Note: make sure spacers lay flat on end panel and horizontal. Loosely install M8 bolt and conical
washer ④⑥ into existing weldnut.
teeth side towards hitch
©2020 Horizon Global Americas Inc. - Printed in Mexico
Sheet 8 of 27
24992NP
2-14-20
Rev. A
Tabla de contenido
