STAR Water Systems HSP10P1 Manual Del Usuario página 20

PUMP PRIMING AND STARTUP
IMPORTANT: If the pump fails to prime within five minutes:
7. Turn the power off at the break box. Check all pipe connections for leaks, making sure all
connections are water and air tight. Check the inlet pipe for any sagging, making sure the inlet pipe
is in a straight line to the pump. Watch for leaks or a milky color in the discharged water, which
indicated an air leak. Re-prime if necessary, following steps 1 through 6. Reset breaker at the
breaker box.
IMPORTANT: If the pump hums instead of pumping or turns off repeatedly, shut pump off
immediately. Check voltage. Pump is wired to run on 230 volts. If the pump cuts out or stops, you may
be attempting to connect to 115 volts. See PUMP ELECTRICAL INSTRUCTIONS Page 17 to see how
to correctly change the motor voltage to 115 volts.
SPECIFICATIONS
Model
HSP10P1
HSP15P1
HSP20P1
MOTOR DATA CHART - HSP SERIES
HP Phase
1
1-1/2
2
Suction
HP
Lift (FT)
15
10 3420
15 2820
1
20 2640
25 1440
10 4092
15 3780
1-1/2
20 3366
25 2520
10 4309
15 3894
2
20 3557
25 2640
Code
Volts Letter
1 115
H
1 230
1 115
G
1 230
1 115
G
1 230
PERFORMANCE
Capacity - U.S. Gallons per Hour
Discharge Pressure (PSI)
20 25 30
3120 2700 2100
2640 2220 1800
2520 2160 1500
1380 1320 1020
3894 3564 3168
3660 3420 2970
3300 2838 2640
2490 2430 2280
4172 4036 3625
3780 3600 3300
3488 3420 3215
2599 2531 2430
20
Locked
Max Rotor
Amps Amps
17.6 62.0
8.8 31.0
18.00 72.0
9.00 36.0
21.00 108.0
10.50 54.0
Suction
Pipe
35 40
1200 0
600 0
2"
480 0
300 0
2508 1716
2310 1188
2"
1848 600
1452 0
3078 2462
2772 2112
2"
2531 1573
2220 720
Discharge
Pipe
1-1/2"
1-1/2"
1-1/2"