Tripp-Lite B110-SP-POE Guia De Inicio Rapido página 3

Installation
Note: The following instructions assume that two PoE devices are currently connected
together.
Single Device Protection:
1. Disconnect the installed patch cable from the device you wish to protect
and attach this cable to the "Cable End" of the In-Line 1G PoE Surge
Protector.
2. Using a Cat5/5e/6 patch cable (not included), connect the device to be
protected to the "Equipment End" of the In-Line 1G PoE Surge Protector.
Note: For the best protection performance, the patch cable between the
"Equipment End" of the In-Line 1G PoE Surge Protector and the equipment to
be protected should not exceed 300 ft. (90 m). Tripp Lite's N001-Series Cat5e
Snagless Patch Cables are recommended.
3. Connect the ground wire to the In-Line 1G PoE Surge Protector and then
to earth ground.
PoE Equipment
(Protected)
In-Line 1G PoE
Surge Protector
PoE Sources
(Unprotected)
20-06-208 93-38D3.indb 3 20-06-208 93-38D3.indb 3
IP Phone PoE Camera
OR
OR
PoE Hub PoE NVR
3
Equipment End
Cable End
7/19/2021 11:10:52 AM 7/19/2021 11:10:52 AM