Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. Install hitch – Align bumper beam with hitch on the floor. Raise the hitch and bumper beam into position aligning holes to the studs on the end panel. Reinstall metal
wiring harness bracket to the stud and loosely install (6) M10 flange nuts to the bumper beam and hitch, see Figure 1.
6. Tighten all M10x1.5 fasteners with torque wrench to 38 Ft.Lb. (52 N*M).
7. Trim lower fascia – Using a tape measure, marker, and utility knife, measure, mark, and trim the lower fascia as shown in Figure 2.
©2021 Horizon Global™ Corp - Printed in Mexico
C
of Vehicle
L
��
1
"
��
��
8
"
��
Figure 2
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Sheet 6 of 21
76525NP
06-25-21
Rev. A
Tabla de contenido
